WEEK 9 (5/12/2022 - 9/12/2022)

-

 UPDATE OF MY PROJECT: 

I've drafted a picture of how the project will be. Below is a sketch of how the project might be:



        But, the problem that I've encountered is the type of fingerprints scanner that I'll be using in this project. I need to use a precise and accurate that will low time consuming to verify the fingerprints. Since I've decided the project will be environmentally friendly and convenience.

Comments

Post a Comment

Popular posts from this blog

FYP 2, WEEK 14 (12/6/2023 - 16/6/2023)

-
Image
During this week, I just focused on organizing and completing all the reports. Below are the list of reports that need to be completed: 1) Final Report (FR) 2) Progress Report (PG) 3) Proposal Report (PR) 4) Technical Paper (TP) Update:  I have completed the technical paper and submitted to the Ms Teams. Proof of submitting can be refer below: 
Read more

FYP 2, WEEK 9 (8/5/2023 - 12/5/2023)

-
Image
This week, I encountered an issue with the LCD display in my project. Upon initial testing, as shown in Figure 1, the LCD was unable to display any content. After conducting a thorough troubleshooting process, I discovered that the problem stemmed from the weak internet connection between the ESP32 and the cloud. To resolve this, I decided to switch to a different Wi-Fi connection with a stronger signal. The positive outcome of this adjustment can be seen in Figure 2, where the LCD successfully displays the desired information. Figure 1 Figure 2
Read more

FYP 2, WEEK 11 (22/5/2023 - 26/5/2023)

-
Image
After programming and testing the website, it was time to make the casing for the project. I bought a case from Mr DIY, a popular hardware store.  I sized the case to fit the LCD panel, keypad, fingerprint scanner, and servo motor. I had to be accurate so each component fit with the casing. I wanted people to easily access all functions. I slowly cut the case with following the measurement of my components. The detail was essential throughout. I needed to ensure the LCD are clear to seeing, the keypad had enough area for comfortable use, the fingerprint scanner was conveniently positioned for authentication, and the servo motor had enough room to function without obstructions.  I wanted the hardware and software to work together. The improved of the casing will protect internal components and looked good to users. It has to be ergonomic, functional, and attractive.  All the processes can be seen below. Figure 1: Cutting Process Figure 2: Assembly Process Figure 3: Final P...
Read more